X-Line Projector Trigger
The projector trigger essentially functions as a remote control. It is connected to the projector's power supply cable and detects the amount of power consumed by the projector. When the projector consumes more power than the set threshold, a signal is sent to the motor in the projection screen to roll it down. If the power consumption falls below the set value, the screen rolls up.
The projector trigger is compatible with X-Line projection screens and our other products that use motors controlled by radio (433.92 MHz). In other words, it can also roll down sunshades and blackouts in windows simultaneously as the projector is started.
On the back of the projector trigger, there are two holes marked CODE and SET. Inside the holes, there are buttons that you can access with, for example, a toothpick. When you are going to pair the projector trigger with a projection screen, make the projection screen powerless and press the CODE button on the projector trigger. Reconnect the power to the projection screen, release the CODE button, and press it again within 10 seconds. Now the projection screen and projector trigger are paired.
To set the power, make the motor powerless and reconnect it. Press SET for three seconds and see that the trigger's LED flashes, then start the projector within ten seconds with the energy setting you will use, and the trigger will now self-adjust to the power strength. If the trigger's LED flashes three times, everything has gone as planned; if it blinks once, you will have to try again.